Water Pik is making your daily shower better with 3D printing

Water Pik is making your daily shower better with 3D printing

Thứ ba - 22/12/2015 09:21

 

mấu in 3D vòi sen Waterpik

Water Pik engineers have used 3D printing technology and rapid prototyping at their Fort Collins, Colorado headquarters for nearly 20 years at their R&D labs to create their shower heads, and they say 3D printing gives their engineers the opportunity to fine-tune and design better shower heads.

Using rapid prototyping, they create computer-based 3D designs before quickly turning them into physical prototypes for testing, and they say the process is some ten times faster from start to finish than traditional prototyping methods.

Mike Quinn, the Lead Shower Design Engineer at Fort Collins, says that after testing, engineers can refine the design and print iterations of prototypes until the design is exactly correct to meet Water Pik’s “OptiFLOW” performance standards.

Quinn says 3D printer technology also allows Water Pik designers to experiment and accomplish product innovations from the SprayShaper shower head to the EasySelect spray selector.

đầu in 3D water pikAs 3D printing enters the mainstream and designers take on a wide range of challenges, the speedy production and prototyping process had led to a variety of takes on item for the shower, and aquick search of Thingiverse reveals the options available to those bored with their standard design.

Water Pik say that a product development process which once took six months to complete as they created and tested prototypes can now be done in just days, and all due to 3D printing.

With a pair of 3D printers, the company manufactures shower head and internal engine components simultaneously as a way to test new designs. Quinn says that while the printing process may take anywhere from several hours to a couple of days to complete, once all production is done, the testers combine the various elements to measure water flow, spray patterns and other factors used to fine tune the “comfortable showering experience.”

Check out this video detailing the company’s use of 3D printers in their design process:

Ken Hair, Vice President of New Products and Engineering at Water Pik, says the process is key to his company as they face competitors.

“Water Pik’s history and position of being the number-one branded replacement shower head company could not have been achieved without the ability to constantly introduce new innovative products—all developed using 3D printing over the past two decades,” says Hair.

The company designs their shower heads using 3D software, uses multiple 3D printers to create different components and then tests them in a dedicated “spray testing booth.” Over the years, Water Pik has developed rigorous shower head testing processes such as flow testing, distance testing and water force testing.

Testing is critical to Water Pik’s development process as the amount of moving water from a shower head, measured in gallons per minute, is mandated by government regulations which limit shower head flow to a maximum output of 2.5 gallons per minute.

đầu vòi sen in 3D

Source: www.stratasys.com

Total notes of this article: 0 in 0 rating
Click on stars to rate this article

Newer articles

Older articles

 
Back Top